Arista Layers | By Seeka

Hello and welcome! Seeka here and today I’m sharing a card featuring the Arista Layer Die set. I really like the detail in the middle layer of this set!

I began by cutting out the three layers of the medallion. The top layer is from a metallic rose cardstock, the middle layer is from a very soft pink cardstock, and the bottom layer is from a grapefruit pink cardstock.

Using a blending brush, I blended a peach colored ink into the middle of the bottom layer. Then I adhered the three layers together.

Next, I used the Handwritten Hugs And Outline die to cut the sentiment from the grapefruit cardstock. I placed the sentiment onto the sticky side of a piece of Post-It tape to hold it in place while I blended some of the same peach ink onto the bottom half of the sentiment. Then, I cut the sentiment’s shadow layer from the light pink cardstock and adhered the two pieces together.

To assemble the card, I cut an A2-sized piece of white cardstock and an A2-sized piece of the light pink cardstock. I trimmed 3/8″ off the length and width of the white cardstock and adhered it to the light pink cardstock. Then I trimmed off a little bit of the medallion, backed it with foam tape, and adhered it to the white cardstock. Next, I adhered the sentiment with a bit of foam tape and glue. To finish, I adhered the card front to a card base.

Thank you so much for visiting today!


Supplies


« »

© 2024 Birch Press Design.