Hello and welcome! Seeka here and today and I’m sharing a clean and simple card featuring the Eucalyptus Stem and Berries Contour Layers die set.

I started off by die cutting two sets of the base layer of eucalyptus leaves from a light blue cardstock. Then, I die cut the detail pieces from a sage cardstock. I glued the small sage pieces to the base layers and then set them aside.

Next, I cut the base layer of the berries die from the same sage cardstock and I cut the berries from a very pale pink cardstock. I glued the berries to the base layer and then set the piece aside.

For the sentiment, I used the Hello Topper die set. I cut the detail sentiment from a mustard yellow cardstock and cut the shadow layer from white cardstock.

I used a rounded rectangle die form my stash to cut a panel of white cardstock and also to cut the shadow layer of the sentiment. Using foam tape, I adhered the sentiment shadow layer to the bottom of the rounded rectangle and then I added the leaves and berries, gluing them down and using foam tape to add a bit of dimension behind some leaves.

To finish, I used foam tape to adhere the rounded rectangle piece to an A2-sized card base.

Thank you so much for visiting!


Supplies